EN
69
12 Parameter's index
PARAM .
FACTO RY
DEFAULT
DESCRIPTION PAGE
$
see chap. 13
Selecting automation system model 71
$
Automatic closure after pause time (from gate completely open) 71
$
Automatic gate closing after mains power outage 71
$
Selecting step mode control function (PP) 71
$
5WJܫFXMNSL 71
$
Condominium function for partial open command (PED) 71
$
Enabling operator present function 72
$
Gate open indicator / photocell test function and “battery saving” 72
Setting deceleration during opening (and closing for BH30/603 - BH30/604 -
BH30/803 - BH30/804 - BM30/400)
72
Setting deceleration during closing (High Speed and Reversible Series only) 72
Setting gate open limit switch constant speed approach distance 72
Setting gate closed limit switch constant speed approach distance 72
Partial opening adjustment (%) 72
Adjusting automatic closing time after partial opening 72
COR output operating mode 72
Setting automatic closing time 72
Enabling of management for opening with automatic re-closure exclusion
73
Setting reverse time after activation of sensing edge or obstacle detection (crush
prevention)
73
Setting motor torque
73
Setting obstacle impact force sensitivity
73
Setting start acceleration during opening (and closing for BH30/603 - BH30/604
- BH30/803 - BH30/804 - BM30/400)
73
Setting start acceleration during closing (High Speed and Reversible Series only)
73
Enabling maximum torque boost at start of manoeuvre
73
Setting motor torque during position recovery 74
Setting opening speed (%) (and closing for BH30/603 - BH30/604 - BH30/803
- BH30/804 - BM30/400)
74
Setting closing speed (%) (High Speed and Reversible Series only) 74
Setting end of manoeuvre constant approach speed 74
Setting number of automatic closure attempts after activation of sensing edge or
obstacle detection (crush protection)
74
Setting photocell mode during gate opening (FT1) 74
Setting photocell mode during gate closing (FT1) 74
Photocell (FT1) mode with gate closed 74
Setting photocell mode during gate opening (FT2) 75
To Next Page
Loading...
