PRT-LT Series Readers fv1.25 Rev. G 2016-10-08
Page 5 from 17
3.2. PROGRAMMING THE PRT-LT READERS WITHOUT KEYPAD
Although some PRT-LT readers are not equipped with keypad still they can be programmed
manually according to the same programming procedures as readers with keypad. The difference
in programming is so that instead of pressing certain keys (like you normally do when
programming readers with keypad) you must emulate keys by multiple readings of the any
proximity card (this card will be latter called Programming Card). So called Programming Card can
be any proximity card – once you read it during programming continue to use it later during entire
cycle of programming. Of course, next time you will perform programming again you can use the
same or another prox. card as Programming Card. For example in order to emulate key [9] you
must read the designated Programming Card 9-times (simply present it to the reader and take it
back 9-times) and then wait approx. 3 seconds for the reader to generate a confirmation signal
(two beeps) which means that series of card readings were accepted as an equivalent of a single
key press and the reader is waiting for the next step of the programming procedure.
Key Emulation Method
[1] Read Programming Card 1-time
[2] Read Programming Card 2-times
[3] Read Programming Card 3-times
[4] Read Programming Card d 4-times
[5] Read Programming Card 5-times
[6] Read Programming Card 6-times
[7] Read Programming Card 7-times
[8] Read Programming Card 8-times
[9] Read Programming Card 9-times
[0] Read Programming Card 10-times
[*] Read Programming Card 11-times
[#] Read Programming Card 12-times
Note: Each time you complete the sequence of multiple readings of the
Programming Card wait for the reader to generate confirmation signal (two
beeps) which will confirm that reader has accepted series of card readings as
the emulation of a single key press.
Example: In order to emulate following programming sequence [*][1][0][ID][#] where ID=113 do
following:
1. [*]: Read 11-times your Programming Card and then wait for two beeps
2. [1]: Read 1-time your Programming Card and then wait for two beeps
3. [0]: Read 10-times your Programming Card and then wait for two beeps
4. [1]: Read 1-time your Programming Card and then wait for two beeps
5. [1]: Read 1-time your Programming Card and then wait for two beeps
6. [3]: Read 3-times your Programming Card and then wait for two beeps
7. [#]: Read 12-times your Programming Card and then wait for two beeps
To Next Page
Loading...
