Rogers Ignite TV XR11

To Next Page

How to use your Ignite TV Voice Remote: Program & pair

BEFORE YOU START:

• Find out which of these Ignite TV

voice remotes you own:

XR11 Voice Remote

XR15 Voice Remote

• Power on. Turn on your TV and/or audio device.

• Check your batteries. Press any button on the voice remote until the LED light turns either

red or green. If the LED does not light up, replace your batteries.

LED on XR11

LED on XR15

• Check Voice Commands Press the Mic button on the Voice Remote and say, “Help”.

Main Page

Need help?

Do you have a question about the Rogers Ignite TV XR11 and is the answer not in the manual?

Summary

Ignite TV Voice Remote Setup and Pairing

Check Voice Remote Batteries

Verify the voice remote batteries are functional by pressing any button. The LED should illuminate red or green.

Pairing Your Voice Remote with Ignite TV Box

Pairing the XR11 Voice Remote

Steps to pair the XR11 remote with the Ignite TV box using the Setup button and a 3-digit code.

Pairing the XR15 Voice Remote

Steps to pair the XR15 remote with the Ignite TV box using Rogers and Info buttons.

Programming Voice Remote for TV Control

Programming XR11 for TV Power and Volume

Instructions to program the XR11 remote for TV power and volume control via specific button sequences.

Programming XR15 for TV Power and Volume

Instructions to program the XR15 remote for TV power and volume control using button sequences.

Programming Voice Remote for Other Devices

Pairing with AV Receivers and Sound Bars

Guide to programming the voice remote to control AV receivers and HDMI compatible sound bars.