V L F > H F R E C E I V E R S
f
E K 8 9 5 / E K 8 9 6
Operator Manual
ME> = memory (activating the buffer contents)
MEM = memory manipulation
MGC = manual gain control
MCU = microcontroller unit
MOD = modulation
NB = noise blanker
NF = notch filter
NTCH = notch filter
OP = option
OPT = option
P = level line status
PA = preamplifier
PAMP = preamplifier
PBT = passband tuning
PC = Personal Computer
PL = level line
PREAMP = preamplifier
PRO = programming (of scanning)
PROC = processor
RAM = random access memory
REM = remote (receiver is remotely controlled)
RF = radio frequency
RS = reactivating a channel
SA = signal BYPASS
SCA = scanning commands
SE = switching digital selection on or off
SER = serial interface
SHFT = shift (frequency offset)
SIG = signal BYPASS
SPEC = special functions
SQ = syllable squelch
ST = store
STCH = store channel (storing current
operation settings in a particular channel)
STO = store (storing current operation
settings in the next free channel with the
lowest channel number)
SYNTH = synthesizer
SYS = system functions
THLD = threshold (digital threshold)
TTY = teletype
USB = upper sideband
V = version (software version)
VAR = variable stepwidth
VERS = version (software version)
VLF = very low frequency
EF = frequency offset
6075.6991.82.01
> V.2 >
To Next Page
Loading...
