Rohde & Schwarz ESH2-Z3 - Required Measuring Equipment

R&S ESH2-Z3 Required Measuring Equipment
1156.6124.32 9 E-1
3 Required Measuring Equipment
Item Designation, required specifications
Recommended R&S equipment
Type Order No.
1 Network analyzer 9 kHz..100 MHz R&S ZVR 1127.8551.61
2 Calibration kit
3 2 x BNC measurement cable
4 2 x BNC connector 0017.6559.00
5 BNC-T connector 0017.6588.00
6 Adapter BNC-banana plug 0017.6742.00
Recalibration
Recalibration of the Passive Voltage Probe R&S ESH2-Z3 is carried out by a two-port measurement
using the test setup shown below.
Test setup:
Remove crocodile clamp from earth cable. So the banana plug can be put into the BNC-banana
adapter.
ZVR
BNC-T
Adapter BNC-banana plug
ESH2-Z3 with
main voltage tip
50 Ohm
BNC connector
red
black
Cable2
Cable1
Measurement:
feed through (S21) 9 kHz..30 MHz:.................................................................................. -30 dB +1/-5 dB
Typical result of S21: