Instrument Tour
R&S
®
FPL1000
47Getting Started 1323.1602.02 ─ 07
5.2.11 IF/Video Output
The female BNC connector can be used for various outputs in the Spectrum
application:
●
Intermediate frequency (IF) output of approximately 20 MHz
●
Video output (1V)
Which output is provided is defined in the software ("Overview" > "Output").
This connector is only available if the R&S FPL1-B5 option is installed.
For details, see the user manual.
5.2.12 Headphones Connector
The R&S FPL1000 provides demodulators for AM, FM and PM signals, which can
be routed to the headphone connector. With headphones or an external loud-
speaker connected to the 3.5 mm headphone socket, the displayed signal can be
identified acoustically.
This connector is only available if the R&S FPL1-B5 option is installed.
Note the safety information provided in "Connecting headphones" on page 11.
For details, see the user manual.
5.2.13 Noise Source Control
The Noise Source Control female connector is used to provide the supply voltage
for an external noise source. For example, use it to measure the noise figure and
gain of amplifiers and frequency converting devices.
This connector is only available if the R&S FPL1-B5 option is installed.
Conventional noise sources require a voltage of +28 V to be switched on and 0 V
to be switched off. The output supports a maximum load of 100 mA.
5.2.14 Device ID
The unique device identifier is provided as a barcode sticker on the rear panel of
the R&S FPL1000.
Rear Panel View
To Next Page
Loading...
