Rohde & Schwarz R&S FSH - Page 69

Module Replacement R&S FSH
1145.5973.82 3.18 E-11
Replacing the binder and BNC connector block
(See exploded view for references).
 Open the instrument.

Disconnect the flat cable (X10).
 Disconnect the connector (X7).
 Remove the binder and BNC connector block:
 Loosen the four (S8) screws.
 Remove the connector block.
 Mount the binder and BNC connector block with the four (S8) screws.
 Connect the connectors (X7).
 Mount the flat cable (X10).
 Close the instrument.
 Perform the quick verification test.
Refer to Chapter 2 “Adjustment”.
S8
S8
S8
S8
X10
X7
Fig. 3-13 Replacing the Binder and BNC connector block