Operating Concepts
R&S
®
NRP Series
41Getting Started 1419.0170.02 ─ 12
b) Select "Sensor > Zero (Signal off) ".
4. Switch on the test signal of the signal source.
5. For a continuous average measurement, select "Measurement" > "Continu-
ous".
The "Continuous" measurement window appears. It shows the measurement
results numerically and some parameters that can be configured.
6. To start the measurement press "Measurement" > "Start".
The measurement result is shown in the "Continuous" measurement window.
For a detailed description of how to measure in this setup, refer to the operating
manual of your R&S Power Viewer. The manual is installed automatically during
the installation of the R&S Power Viewer.
R&S Power Viewer
To Next Page
Loading...
