Need help?Do you have a question about the Rohde & Schwarz R&S NRP18T and is the answer not in the manual?
General| Storage Temperature Range | -40 °C to +70 °C |
|---|---|
| Measurement Type | Average power |
| Calibration | Factory calibrated |
| Connector Type | N-type |
| Connector | N-type |
Deals with security issues when working with the power sensor in secure areas.
Contains safety instructions, operating conditions, and further important information.
Check equipment for completeness and inspect the power sensor for any damage.
Specific conditions required for accurate measurements and to avoid damage.
Notes on handling, contamination risk, and preventing electrostatic discharge (ESD).
Instructions on connecting the power sensor to a DUT using the RF connector.
Describes how to connect a cable from the power sensor to a USB host.
Operate the power sensor using a computer via software, web UI, or remote control.
Integrate LAN power sensors into a network for remote control via Ethernet.
Describes the RF connector and tightening torque for various power sensors.
Interface for establishing a connection between the power sensor and a USB host.
Details the RJ-45 connector, PoE requirement, reset button, and status LEDs for LAN sensors.
Basic software package for low-level drivers and tools for all power sensors.
Using the integrated browser-based GUI for LAN power sensors for configuration and measurement.
Easily controlling the R&S NRP series power sensor remotely.
To Next Page
