Rohde & Schwarz R&S NRP18T - R&S NRP Power Sensors Tour

R&S NRP Power Sensors Tour
R&S
®
NRP Series
25Getting Started 1419.0170.02 ─ 12
5 R&S NRP Power Sensors Tour
This chapter provides an overview of the available connectors and LEDs of the
power sensor.
In Figure 5-1, the USB power sensor is shown on the left, the LAN power sensor
is shown on the right.
1
1
2
3
4
4
7
8
5
2
3
HOST
INTERFACE
IN:
3 V or 5 V logic
OUT: min. 2 V into 50
Ω
max. 5.3 V
TRIG2
I/0
PoE
SMART SENSOR TECHNOLOGY
NRP
SMART SENSOR TECHNOLOGY
NRP
6
Figure 5-1: R&S NRP series power sensors (example)
1 = RF connector, see Chapter 5.1, "RF Connector", on page 26
2 = Trigger I/O connector, see Chapter 5.2, "Trigger I/O Connector", on page 27
3 = Host interface connector, see Chapter 5.3, "Host Interface", on page 28
4 = Status LED, see Chapter 5.4, "Status LED", on page 28
5 = LAN connector, see Chapter 5.5, "LAN PoE Interface", on page 29
6 = LAN reset button, see "LAN reset button" on page 29
7 = Power over Ethernet status LED, see "Power over Ethernet status LED" on page 29
8 = Network status LED, see "Network status LED" on page 29