Operating Concepts
R&S
®
NRP Series
37Getting Started 1419.0170.02 ─ 12
●
Chapter 4.6.1, "Computer", on page 14
6.4 R&S NRPV
The R&S NRPV enables you to measure power in all available measurement
modes. Also, you can use up to four power sensors simultaneously.
The R&S NRPV is provided on your documentation CD-ROM and on the Rohde
& Schwarz website as a separate standalone installation package.
Required equipment
●
R&S NRP power sensor
●
R&S NRP‑ZKU cable or an R&S NRP‑Z5 sensor hub and an R&S NRP‑ZK6
cable to connect the sensor to the computer
●
Windows computer with installed:
– R&S NRP Toolkit V 4.17 or higher
– R&S NRPV version 3.2 or higher (refer to the operating manual of the R&S
NRPV for a description of the installation process)
Setup
Figure 6-2: Setup with an R&S NRPV
1 = Signal source
2 = R&S NRP power sensor
3 = Host interface connector
4 = R&S NRP‑ZKU cable
5 = USB connector
6 = Computer with installed R&S NRPV
R&S NRPV
To Next Page
Loading...
