Firmware V3.12
R&S
®
ZNB/ZNBT
17User Manual 1173.9163.02 ─ 53
3 Firmware V3.12
Version 3.12 of the R&S ZNB/ZNBT firmware provides the following changes:
Solved issues
●
Firmware versions 3.x created incompatible *.calkit files
(*.calkit files containing snp data could not be used with previous FW versions)
●
R&S ZNBT8 with CPU board "LPW10" and image version "1.0 (64 Bit)": update to
firmware versions 3.x failed
CPU board and image version can be found in the "Image Information" section of
the setup info.
●
PC firmware simulation failed to run due to missing Microsoft Visual C++ redistrib-
utable
Firmware version
► To check your R&S ZNB/ZNBT firmware version, select "Help" > "About..." from the
main menu.
3.1 Changes in Firmware Version 3.11
Solved issues
●
Problems with fan control
●
Impedance normalization failed for some special balanced port configurations
●
User characterization of R&S ZN-Z154 did not work
●
Firmware simulation: trace noise could not be disabled in Simulation Config tool
3.2 Changes in Firmware Version 3.10
New functionality
●
Ground loop de-/embedding per port group (i.e. per DUT)
See "Ground Loop per Port Group" on page 600
●
New "Distance to Fault Measurements" software option R&S ZNB-K3/R&S ZNBT-
K3
See Chapter 5.7.3, "Distance to Fault Measurements", on page 215
New remote control features
●
Memory-mapped trace data transfer
See Chapter 5.4.3, "Memory-Mapped Trace Data Transfer", on page 146
Improvements
●
Limit line enhancements:
– Formula-defined limit lines
See "Response Dialog" on page 351
Changes in Firmware Version 3.10
To Next Page
Loading...
