Instrument tour
R&S
®
RTA4000
24Getting Started 1335.7881.02 ─ 05
Logic probe
The connectors for logic channels can be used if the Mixed Signal Option
R&S RTA-B1 is installed. The option provides connectors for two logical probes
with 8 digital channels each (D0 to D7 and D8 to D15).
The maximum input voltage is 40 V (peak) at 100 kΩ input impedance. The maxi-
mum input frequency for a signal with the minimum input voltage swing and
medium hysteresis of 800 mV (Vpp) is 400 MHz.
4.3 Rear view
Figure 4-3 shows the rear panel of the R&S RTA4000 with its connectors.
Figure 4-3: Rear panel view of R&S
RTA4000
1 = Aux Out connector
2 = USB connector, type B
3 = LAN connector
4 = AC power supply connector and main power switch
Rear view
To Next Page
Loading...
