This manual describes the following R&S
®
RTA4000 models with firmware version 1.7xx:
●
R&S
®
RTA4004 (1335.7700K04)
In addition to the base unit, the following options are described:
●
R&S
®
RTA-K1, I²C/SPI trigger and decode
●
R&S
®
RTA-K2, UART/RS232 trigger and decode
●
R&S
®
RTA-K3, CAN/LIN trigger and decode
●
R&S
®
RTA-K5, I²S (audio) trigger and decode
●
R&S
®
RTA-K6, MIL.1553 trigger and decode
●
R&S
®
RTA-K7, ARINC 429 trigger and decode
●
R&S
®
RTA-K18, Spectrum analysis (replaced by K37)
●
R&S
®
RTA-K31, Power analysis
●
R&S
®
RTA-K36, Bode plot analysis
●
R&S
®
RTA-K37, Spectrum analysis
●
R&S
®
RTA-B1, Mixed signal option
●
R&S
®
RTA-B6, Arbitrary waveform and pattern generator
For order numbers of the options and bundlles, refer to the data sheet.
© 2021 Rohde & Schwarz GmbH & Co. KG
Mühldorfstr. 15, 81671 München, Germany
Phone: +49 89 41 29 - 0
Email: info@rohde-schwarz.com
Internet: www.rohde-schwarz.com
Subject to change – data without tolerance limits is not binding.
R&S
®
is a registered trademark of Rohde & Schwarz GmbH & Co. KG.
Trade names are trademarks of the owners.
1335.7898.02 | Version 08 | R&S
®
RTA4000
Throughout this manual, products from Rohde & Schwarz are indicated without the
®
symbol, e.g. R&S
®
RTA4000 is indicated as
R&S RTA4000.
To Next Page
Loading...
