Rohde & Schwarz RTA4000 - Horizontal Settings

Remote control commands
R&S
®
RTA4000
452User Manual 1335.7898.02 ─ 08
PROBe<m>:PMETer:RESults:NEGative?
The command is available only for Rohde & Schwarz modular probes that have an
R&S ProbeMeter.
It returns the voltage that is measured between the negative signal socket and the
ground.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Return values:
<ResultValue> Default unit: V
Usage: Query only
PROBe<m>:PMETer:RESults:POSitive?
The command is available only for Rohde & Schwarz modular probes that have an
R&S ProbeMeter.
It returns the voltage that is measured between the positive signal socket and the
ground.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Return values:
<ResultValue> Default unit: V
Usage: Query only
17.4.7 Horizontal settings
TIMebase:SCALe...........................................................................................................452
TIMebase:POSition........................................................................................................ 453
TIMebase:REFerence.....................................................................................................453
TIMebase:ACQTime.......................................................................................................453
TIMebase:RANGe..........................................................................................................453
TIMebase:DIVisions?......................................................................................................454
TIMebase:RATime?........................................................................................................454
TIMebase:SCALe <TimeScale>
Sets the horizontal scale for all channel and math waveforms.
Waveform setup