Instrument Tour
R&S
®
RTE
23Getting Started 1326.1026.02 ─ 08
Figure 4-2: Rear panel view of R&S
RTE
1 = AC power supply connector and main power switch
2 = USB connectors
3 = LAN connector
4 = DVI-D connector for external monitor
5 = Optional exchangeable solid state disk (SSD), option R&S R
TE-B18
6 = External trigger output
7 = Reference input/output
8 = Slot for hardware option: mixed signal option R&S R
TE-B1 (shown in picture), or waveform
generator R&S RTE-B6, or GPIB connector R&S RTE-B10)
9 = Kensington lock slot to secure the instrument against theft
10 = Lugs to attach the accessory bag
AC power supply connector and main power switch
Connection to the AC power line. The R&S R
TE can be used with different AC
power voltages and adapts itself automatically to it. The nominal voltage and fre-
quency ranges are displayed on the rear panel and quoted in the data sheet.
If grounding is not ensured by the mains system, ground the oscilloscope using
the protective earth conductor on the front panel and an appropriate cable.
Rear Panel
To Next Page
Loading...
