Rohde & Schwarz RTE Series - Page 97

Operating the Instrument
R&S
®
RTE
97Getting Started 1326.1026.02 ─ 08
For direct access to important control and measurement functions use the
toolbar
, see Chapter 6.7, "Toolbar", on page 86.
To open a dialog box
►
Perform one of the following actions:
● Tap the required menu, and then the menu entry.
● Press the function key on the front panel.
● If a results box is open, tap the
icon to open the corresponding dialog
box.
●
To open the "Vertical" dialog box of a waveform, tap its signal icon. For XY-
waveforms, the "XY Diagram" tab opens.
● Tap the horizontal or trigger label to open the "Horizontal" or "Trigger" dia-
log box, respectively.
To minimize a dialog box
If you want to change only one setting during analysis, and you need to change it
often, you can display a small box that only contains the required setting.
1. Tap the function that you need to modify.
2. Tap the
"Minimize" icon in the upper right corner of the dialog box.
The dialog box turns into a small box that contains only the
"Wfm Arithmetic"
setting.
3. To restore the complete dialog box, tap the "Maximize" icon in the small
box.
T
o close a dialog box
► Tap the "Close" icon in the upper right corner.
Or:
Press the [ESC] key on the front panel.
To select an option in a dialog box
► Tap the required option.
Or:
Using Dialog Boxes
www.allice.de
Allice Messtechnik GmbH