Instrument Tour
R&S
®
RTP
32Getting Started 1337.9946.02 ─ 05
[Trigger]
Opens and closes the "Trigger" dialog box, where you can:
●
Select a trigger type and configure it.
●
Set general trigger parameters and control the acquisition run.
●
Qualify the trigger event with logic patterns.
●
Configure a sequence of subsequent trigger events.
●
Set up the zone trigger if option R&S RTP-K19 is installed.
[Levels]
The rotary knob sets the trigger level for all trigger types. Turn clockwise to move
up the trigger level. If the selected trigger type requires two trigger levels - upper
and lower level - press the knob to toggle between the two levels.
[Source]
Opens a dialog box where you can select the trigger source. Press the key again
to switch the source. The key lights up in the color of the selected trigger source.
[Slope]
Toggles the trigger slope or trigger polarity, dependent on the trigger type. The
current setting is shown on the trigger label, which is in the upper part of the side-
bar.
Keys and Controls
To Next Page
Loading...
