Instrument Tour
R&S
®
RTP
33Getting Started 1337.9946.02 ─ 05
[Mode]
Toggles the trigger mode between Auto and Normal. The current setting is shown
on the trigger label.
[Run Stop]
Starts and stops the continuous acquisition. A green light indicates a running
acquisition. A red light shows that acquisition is stopped.
[Single]
Starts a defined number of acquisitions. A green light indicates a running acquisi-
tion. A red light shows that acquisition is stopped. Press the key again to stop
running acquisitions.
To set the number of acquisitions, press the [Trigger] key, select the "Ctrl/Action"
tab, and set "Average count (N-single count)".
4.3.6 Analysis Keys
The keys in the Analysis functional block provide direct access to measurement
and analyzing functions. If you press [Cursor], [Zoom] or [Meas], the action starts
on first keypress, and a second keypress opens the corresponding dialog box. If
you press another function key, the dialog box opens.
[Cursor]
Displays vertical and horizontal cursors in the active diagram and opens the "Cur-
sor Results" box.
Cursors are markers which are placed at points of interest on a waveform. The
instrument measures the cursor positions and delta values between parallel cur-
sors.
If you press the key while a cursor measurement is enabled, the "Cursors" dialog
box opens.
In the "Cursors" dialog box, you can:
●
Configure up to 4 cursor sets
Keys and Controls
To Next Page
Loading...
