Instrument Tour
R&S
®
RTP
34Getting Started 1337.9946.02 ─ 05
●
Define style and labels of the cursors
●
Connect the cursor to the waveform and couple the cursors
[Meas]
Starts the default automatic measurement for the active waveform and opens the
"Measurement" result box.
If you press the [Meas] key while a measurement is enabled, the "Measurements"
dialog box is displayed, where you can:
●
Configure amplitude and time measurements, eye, spectrum, and histogram
measurements
●
Configure gated measurement
●
Configure long term and statistic measurements
●
Configure actions to be executed if specified limits are exceeded
App Cockpit
Opens the "App Cockpit" dialog box, where you can start an application or analy-
sis function directly, without knowing its position in the menu or toolbar.
The "App Cockpit" button on the left end of the menu has the same effect.
[Zoom]
Displays a zoom diagram for the active diagram. The key is illuminated if at least
one zoom is active. If you press the key while the zoom function is on, the "Zoom"
dialog box opens, where you can configure several zoom areas for detailed signal
observation.
[Protocol]
Opens the "Protocol" dialog box which contains the configuration of serial buses
and the settings for decoding the signals.
The key lights up if the decoding of a serial bus is active. You can switch off the
decoded bus using the [Signal Off] key.
[Search]
Opens and closes the "Search" dialog box, where you can:
●
Configure trigger events to be searched for
●
Limit the search by gating
●
Configure the presentation of search results
[Mask]
Opens and closes the "Masks" dialog box. Masks are used for error detection and
compliance tests of digital signals.
Keys and Controls
To Next Page
Loading...
