Chapter 4 Putting into Operation
5300.9677.72 - 4.10 - EN-4
Note The system must be restarted in order to implement the changes.
2.3 Setting Modulation-Specific Parameters
2.3.1 Selecting the Modulation Mode
To select the modulation mode, proceed as follows:
1. Select Transmitter > Exciter > Automatic Input.
The Automatic Input window opens.
2. Under Channel 1 and Channel 2, assign the appropriate input type and stereo mode to
the main and/or standby signal.
3. Select the active channel under Selection.
The table below explains the adjustable parameters.
Rear Ethernet Manual settings should only be made in the offline mode (context menu:
Edit Offline) and then activated with Submit Changes (context menu).
a)
IP Address IP address
Subnet mask Subnet mask
Gateway Entry of a gateway address (assigned by the network administrator).
a) If the transmitter is configured for use in 1+1 or n+1 standby systems, the IP address cannot be changed.
Entry/display Description
Operating Mode For setting and displaying audio inputs and stereo mode
Two different modulation types can be preselected. It is possible to
switch between them manually or automatically.
Selection Description
To Next Page
Loading...
