Preparing for Use
R&S
®
ZNLE
26Getting Started 1323.2873.02 ─ 08
a) Use a wrist strap and cord to connect yourself to ground.
b) Use a conductive floor mat and heel strap combination.
Instrument damage caused by electrostatic discharge
If you are working in an environment where strong ESD discharges are pos-
sible, Rohde & Schwarz recommends using a broadband limiter
R&S ZN‑B13 (stock number 1303.7840.02) at each port of your R&S ZNLE.
Signal input and output levels
Information on signal levels is provided in the data sheet. Keep the signal levels
within the specified ranges to avoid damage to the R&S ZNLE and connected
devices.
Considerations for Test Setup
To Next Page
Loading...
