Rohde & Schwarz ZVA8 - Default Chapter; Table of Contents

Contents
R&S
®
ZVA
3Quick Start Guide 1145.1090.62 ─ 10
Contents
1 Preparing the Analyzer for Use.............................................................7
1.1 Front Panel Tour...........................................................................................................7
1.1.1 Display............................................................................................................................8
1.1.2 Setup Keys......................................................................................................................9
1.1.3 Navigation Keys............................................................................................................10
1.1.4 Data Entry Keys............................................................................................................11
1.1.5 Rotary Knob..................................................................................................................12
1.1.6 Standby Key..................................................................................................................12
1.1.7 Front Panel Connectors................................................................................................12
1.1.8 Additional Hardware Options........................................................................................14
1.2 Rear Panel Tour...........................................................................................................15
1.3 Putting the Analyzer into Operation..........................................................................16
1.3.1 Unpacking and Checking the Analyzer.........................................................................17
1.3.2 Setting up the Analyzer.................................................................................................18
1.3.3 Bench Top Operation....................................................................................................18
1.3.4 Operation in a 19" Rack................................................................................................19
1.3.5 EMI Suppression...........................................................................................................19
1.3.6 Connecting the Analyzer to the AC Supply...................................................................20
1.3.7 Power on and off...........................................................................................................20
1.3.8 Standby and Ready State.............................................................................................21
1.3.9 Replacing Fuses...........................................................................................................21
1.4 Starting the Analyzer and Shutting Down.................................................................21
1.5 Connecting External Accessories.............................................................................22
1.5.1 Connecting a Mouse.....................................................................................................23
1.5.2 Connecting a Keyboard.................................................................................................23
1.5.3 Connecting a Printer.....................................................................................................23
1.5.4 Connecting a Monitor....................................................................................................24
1.5.5 Connecting a LAN Cable...............................................................................................24
1.5.6 Test Setups with two LAN Connections........................................................................25
1.6 Remote Operation in a LAN.......................................................................................26
1.6.1 Assigning an IP Address...............................................................................................26