Confidential & Proprietary|© ROKIT Healthcare Inc. 2019. All Rights Reserved
Dr. INVIVO 4D Installation
Preparation Before Installation
13
In order to prevent injuries from lifting heavy loads, work in a group of at least two persons to hold or move the equipment
and follow the below guidelines:
- Install the equipment on a flat and solid floor.
Uneven floors can cause vibration and noise, as well as a probable increase of slants for bed leveling and reduction of print
quality.
The floor should be sturdy to withstand the weight of the equipment.
- Install the equipment with some space for ventilation.
Be sure to keep the back side at least 5 cm from the walls for good ventilation.
- Avoid places with direct sunlight, high heat or excessive cold.
Install at an ambient temperature, typically between 5 ℃ and 35 ℃.
If the temperature at the installation place is too high or too low, the heating or cooling function may malfunction and the
print quality may be reduced.
INV-CHS-20191210
Component Width x Depth x Height (mm) Weight (kg) Memo
Invivo Body 690 x 690 x 990 48
Temperature Controller 520 x 480 x 365 16.5
Air Compressor 820 x 550 x 560 49
Air Dispenser Controller 480 x 440 x 205 7
[Packaging specification ]
To Next Page
Loading...