Do you have a question about the Roland BOSS KATANA-50 Mk II and is the answer not in the manual?
Power Output | 50 W |
---|---|
Reverb | Yes |
Amp Modeling | Yes |
Type | Guitar Amplifier |
Speaker Size | 12 inch |
Effects | Delay, Modulation, FX |
EQ | 3-band EQ (Bass, Middle, Treble) |
Inputs | 1 x 1/4 inch |
Outputs | 1 x 1/4 inch |
USB | Yes |
Footswitch I/O | 1 x 1/4" Footswitch Input (for GA-FC compatible footswitch) |
Presets | 8 |
Procedure to back up and restore unit settings to prevent data loss.
Instructions for component replacement, focusing on critical areas.
Explains why certain parts are unavailable as service parts.
Defines abbreviations like "NIU" and "UnPop" used in diagrams.
Details required information for warranty claims.
Lists and identifies parts for top panel controls.
Lists and identifies parts for rear panel controls.
Detailed list of parts comprising the amplifier cabinet.
Crucial precautions for handling electronic components during service.
Illustrated view of cabinet parts and their locations.
Additional illustrated view of cabinet parts and their locations.
Illustrated view of chassis parts and their locations.
Additional illustrated view of chassis parts and their locations.
Procedure to check the current software version.
Steps to save and load user data and settings.
Guide for updating the amplifier's firmware.
Instructions to restore the unit to its default settings.
Procedures for accessing, quitting, and bypassing tests.
Lists and describes the various diagnostic tests available.
Verifies hardware model and software version.
Tests the operation of buttons and indicator LEDs.
Verifies operation of selector knobs and volume controls.
Tests input jacks and foot switch functionality.
Verifies USB connectivity and internal device status.
Measures audio signal levels at various outputs.
Measures residual noise levels in audio outputs.
Detailed schematic for the main circuit board.
Part one of the detailed schematic for the main circuit board.
Part two of the detailed schematic for the main circuit board.
Part three of the detailed schematic for the main circuit board.
Schematics for multiple related circuit boards.
Schematic for the input circuit board.
Schematic for the fuse circuit board.