Roland CM-500 - Troubleshooting and Block Diagram; Troubleshooting Common Issues; System Block Diagram

Ш Problems? Please Check A Few Things First
И the CM-500 is not working as expected, go through this checklist first; the trouble may
be something quite simple. 1f you can't solve the problem, however, contact your dealer
or nearest Roland Service Station.
4 No Sound
ж Are all connected devices turned оп?
* Are all devices connected properly?
* If there is an input selector on your audio device, is it set for the AUX IN or LINE IN
that vou're plugged into?
* Is the volume turned up on the audio device?
ж [s there a volume setting on any software you might be using? Is it turned down or
set to zero?
@ Sounds Don't Sound Right
* Have you changed MIDI cable connections? If the connections are changed in the
middle of play-back, it can cause parts to play with the wrong sounds.
ж Is the Mode set for the sound source you intended to use?
B Brock Diagram
Panel
Volume
Send
Level
Pan
Volume
Part Master Reverb Chorus
Part 2 АА ih
Fecci- 4 —
Part
Volume
Reverb
SW
Е
"Та
он
i .
Rhy the
о
21