Roland CM-500 - Important Notes; Power Supply and Placement; Maintenance

Ш Important Notes
i Power Supply
| Placement |
| Maintenance |
Be sure to use only the adaptor supplied with the unit. Use of any other power adaptor
could result in damage, malfunction, or electric shock.
4 When making any connections with other devices, always turn off the power to all
equipment first; this will help prevent damage or malfunction.
@ Do not use this unit on the same power circuit with any device that will generate line
noise, such as a motor or variable lighting system.
@ The power supply required for this unit is shown on its nameplate. Ensure that the line
voltage of your installation meets this requirement.
Ө Avoid damaging the power cord; do not step on it, place heavy objects on it etc.
® When disconnecting the AC adaptor from the outlet, grasp the plug itself; never pull on
the cord.
@ If the unit is to remain unused for а long period of time, unplug the power cord.
@ Do not subject the unit to temperature extremes (eg. direct sunlight in an enclosed
vehicle) Avoid using or storing the unit in dusty or humid areas or areas that are
subject to high vibration levels.
@ Using the unit near power amplifiers (or other equipment containing large trans-
formers) may induce hum.
@ This unit may interfere with radio and television reception. Do not use this unit in the
vicinity of such receivers.
@ Do not expose this unit to temperature extremes (eg. direct sunlight in an enclosed
vehicle can deform or discolor the unit) or install it near devices that radiate heat.
@ Гог everyday cleaning wipe the unit with a soft. dry cloth (or one that has been slightly
dampened with water. To remove stubborn dirt, use a mild neutral detergent.
Afterwards. be sure to wipe the unit thoroughly with a soft, dry cloth.
@ Never use benzene, thinners, alcohol or solvents of any kind. to avoid the risk of
discoloration and/or deformation.