Need help?Do you have a question about the Roland EDIROL PCR-500 and is the answer not in the manual?
General| Number of Keys | 49 |
|---|---|
| Assignable Knobs | 8 |
| Assignable Sliders | 9 |
| Pitch Bend/Modulation Lever | Yes |
| Octave Shift | Yes |
| Sustain Pedal Input | Yes |
| MIDI Out | Yes |
| USB | Yes |
| Transport Buttons | Yes |
| Function Buttons | Yes |
| Key Type | Velocity-sensitive |
| Power Supply | USB Bus Power or AC Adaptor |
Explains the display and key function buttons like DYNAMIC MAPPING/V-LINK.
Details controls for adjusting MIDI parameters, modes, and octave shifts.
Covers rotary knobs, pads, sliders, and their assignment capabilities.
Describes DC IN, USB, MIDI IN/OUT, and pedal connections.
Explains the MIDI MERGE switch, power switch, and Kensington lock slot.
Defines Control Maps and their purpose in assigning MIDI signals.
Instructions on switching, saving, and receiving Control Maps.
Procedure for sending Control Map data to a computer.
How to prevent accidental deletion of Control Map data.
Explains Pitch Bend, Modulation, and Octave Shift for performance.
How to set MIDI channels and select sounds using MIDI messages.
Selecting sounds for Lower/Upper zones, Dual, and Split modes.
How keyboard velocity affects sound and how to adjust its response.
Transmitting controller states and muting controllers.
Using the PANIC function to reset MIDI signals.
Detailed guide on assigning Note, Aftertouch, CC, PC, RPN/NRPN, SysEx signals.
Examples for assigning GM2 System On, Master Volume, and Bend Pitch Control signals.
Setting input modes (Decimal/Hex) and key behavior.
Virtual center, port settings, copying, and canceling assignments.
Configuring clock signals, keyboard velocity, aftertouch, and port settings.
Configuration of MIDI interface and merge functions.
Settings for specific controllers like Value Encoder and Dynamic Mapping.
Defining Dynamic Mapping/V-LINK and performing a factory reset.
To Next Page
