Roland EM-305 - Page 31

Try Recording a Tune
Let’s use the Recorder function to make a recording. First of all, make all the settings
you need; music style selection, tone selection, and Sync Start.
Press the RECORDER button.
The. REC. indicator. (red) lights and the Recorder. function.is.ready.to.record_ (the
‘record standby’ mode).
* Pressing the RECORDER button again cancels this stand-by status.
Start play by pressing the START/STOP button, or by turning on Sync
Start and playing in the lower section of the keyboard.
Recording starts automatically when the music begins.
End your performance by pressing the START/STOP button or the
INTRO/ENDING button.
Recording stops automatically when the music style accompaniment ends.
QO oo 0 0
INTROENDING wn TEMPO PL ARRON syuc
TO OPAL 30 RATION O sue SLOW Lad
Li stwcaro |
VAP TENROH
* You can record up to approximately 3,500 sounds (notes). When the Recorder
memory is almost full the REC button indicator starts to blink.
Listen io the Performance You Recorded
Now let's listen to the performance you've just recorded.
Press the RECORDER button twice.
The PLAY button indicator (green) lights up.
* Ifthe PLAY indicator doesn’t light up when you press the RECORDER button twice,
it means that there is nothing stored in the recorder. Check to make sure you're
doing everything right and try recording again.
Press twice
lle et Er er
29