26
Apr.2003
13. Encoder
When you enter the Encoder test, the LCD display will show as follows.
fig.13-1_70
Continue turning the [VALUE] dial toward the left, and verify that the LCD
display indicates “Left: 72 OK.”
Next, continue turning the [VALUE] dial toward the right, and verify that the
LCD display indicates “Right: 72 OK.” You will then automatically proceed to
the next test item.
14. A/D
This tests the operation of each rotary control and slide control.
When you enter the A/D test, the LCD display will show as follows.
fig.14-1_70
One by one, operate all controls (other than the [VOLUME OUTPUT] knob
and the [VOLUME INPUT] knob), including the bender, aftertouch,
[CONTROL] jack (connect an expression pedal such as the EV-5), and [HOLD]
jack (connect an expression pedal such as the EV-5), to adjust through their
variable range from MAX to MIN.
Verify that the corresponding indicator in the LCD display becomes lighter.
When all indicators have become light, and the test results are OK, you will
automatically proceed to the next test item.
15. Switch1 & LED
This tests the operation of LED-equipped switches.
When you enter the Switch 1 & LED test, the LCD display will show as
follows.
fig.15-1_70
One LED-equipped panel switch will light.
When you press that switch, the next LED-equipped switch will light.
Repeat this until all switches are OK, and you will automatically proceed to
the next test item.
Pressing two or more switches simultaneously is not valid.
Switches with an LED window will produce the OK result when they are
pressed once. In the case of switches (without a window) located next to
exposed LEDs, the OK result will be produced when you press the switch the
number of times corresponding to the number of exposed LEDs.
When the display for all switches has become lighter, and the test results are
OK, you will automatically proceed to the next test item.
16. Switch2
This tests the operation of switches that were not checked in the Switch1 &
LED test.
When you enter the Switch2 test, the LCD display will show as follows.
fig.16-1_70
One by one, press each switch shown in the LCD display.
Verify that the indication in the LCD display for the corresponding switch
becomes lighter.
When the indications of all switches have become lighter and the test results
are OK, you will automatically proceed to the next test item.
To Next Page
Loading...
