28
Apr.2003
19. USB
This tests USB operation.
When you enter the USB test, the LCD display will show as follows.
fig.19-1_70
Connect a USB cable to your computer (one that has a USB connector; the OS
can be either Windows Me, Windows 2000, or Windows XP).
If the test result is OK, the display will indicate “Status: Connect USB Test
Completed!”
On your computer, use the Safely Remove Hardware icon shown in the
taskbar at the lower right of the screen to break the connection with the
FANTOM-S.
Press the [8] button to proceed to the next test item.
20. Factory Reset
This perform a Factory Reset.
The LCD display will show as follows.
fig.20-1_70
When you press the [ENTER] button, the LCD display will show as follows,
and the factory reset will be executed automatically.
fig.20-2_70
When the factory reset is completed, the LCD display will show as follows,
and you will exit Test mode.
fig.20-3_70
Turn off the power of the Fantom.
RESTORING THE FACTORY
SETTINGS
This restores all data in the Fantom-S to the factory-set condition (Factory
Reset).
If there is important data you’ve created that’s stored in the Fantom-As’s
internal memory, all such data is discarded when a Factory Reset is performed
(the data of the internal user memory will be lost). If you want to keep the
existing data, save it on a SmartMedia or save it on via USB to your computer
1. Press [MENU] to open the Menu window.
2. Press or to select “Utility,” and then press [ENTER].
3. Press [3 (Factory Reset)].
A message will ask confirmation.
4. Press [8 (Exec)] to execute the Factory Reset.
* To cancel, press [7 (Cancel)].
5. When the display indicates “Please Power Off,” turn the power off, then
on again.
SYSTEM SOFTWARE UPDATE
PROCEDURE
The FANTOM-S uses flash memory as its program ROM, and can be updated
using either of the following two methods.
1. Updating from a computer via a USB cable
(Time required: approximately 3 minutes)
2. Updating from SmartMedia via the
Fantom’s SmartMedia card slot
(Time required: approximately 3 minutes)
To Next Page
Loading...
