Roland FR-7 - Restoring the Factory Defaults

Restoring the factory defaults
V-Accordion r
77
(5) Press the [MENU÷WRITE] button to jump to one of
the following pages (not available when you are
saving the Global, Orchestra or Orchestra Bass set-
tings):
(6) If necessary, select another Set and/or another
register than the ones you are currently using.
(You can only select a different Set for the Orches-
tra, Orchestra Bass and Set Common settings.)
Press the [DATA÷ENTER] knob to select “SET” or
“REGISTER”, then turn it to select the number (“1~40”
for SET, “1~14” for REGISTER).
(7) Press the [MENU÷WRITE] button to save your
changes. The display now briefly confirms that
your settings have been stored:
The display returns to the Main page.
(8) Proceed with step (1) above.
Note: See also “At power-on, the FR-7/FR-5 displays the fol-
lowing message” on p. 79.
Restoring the factory defaults
You can reset the FR-7/FR-5 to its factory settings, which means that your own Sets and Global settings are replaced by
the settings the FR-7/FR-5 contained when you first got it. You may wish to archive your settings before initializing the
FR-7/FR-5 (see p. 74).
(1) Switch on the FR-7/FR-5 while holding down the
[MENU÷WRITE] button.
The display changes to:
(2) Press the [DATA÷ENTER] knob to initialize the FR-7/
FR-5 (“YES” is selected by default).
If you decide against initializing the FR-7/FR-5,
rotate the [DATA÷ENTER] knob to select “NO”, then
press it.
If you selected “YES” and pressed the [DATA÷ENTER]
knob, the display now briefly confirms that your
V-Accordion has been initialized:
The FR-7/FR-5 now sounds and behaves like when
you first bought it.
(*)
(*)