Roland FR-8X - Page 2

page | 2
ROLAND FR-8x
How to use Expansion Sound
FR-8x
How to install the Sets
※ This step is unnecessary for expansion sounds that do not contain [.ST8] files.
1. Insert your USB memory in your FR-8x.
2. Press the [MENU/WRITE] button.
3. Select "Utility using" the [DATA/ENTER] knob.
4. Select "IMPORT" 15.9 using the [DATA/ENTER] knob.
5. Press [DATA/ENTER] knob again to highlight the "Type" parameter.
6. Select "SET" using the [DATA/ENTER] knob.
7. Press [DATA/ENTER] knob to confirm.
8. Select "SET File" using the [DATA/ENTER] knob.
9. Press [DATA/ENTER] knob again to highlight the "SET File" parameter.
10. Select "Single" using the [DATA/ENTER] knob.
11. Press [DATA/ENTER] knob to confirm.
12. Select "Dest. SET" using the [DATA/ENTER] knob.
13. Press [DATA/ENTER] knob again to highlight the "Dest. SET" parameter.
14. Select the SET destination where you want to import the SET using the [DATA/ENTER] knob.
15. Press [DATA/ENTER] knob to confirm.
16. Press the [MENU/WRITE] button to proceed. The display shows the contents of the USB memory.
17. Use the [DATA/ENTER] buttons to select a file (.ST8) that you want to import.
18. Press the [MENU/WRITE] button to import.
Please wait until the "Operation complete" message appears.
Press the [EXIT] button several times to return to the previous screen.
■Copyright
Copyright to this data and the accompanying documentation is the property of Roland Corporation.
■Disclaimers
・This sound data is provided as after-sales service for the FR-8x/FR-8xb.
・Roland Corporation accepts no responsibility for any damages that may arise from the use of this data.
Date: August, 25, 2017