Roland GP-9 - Main Specifications

Attach the Other Parts
1. Use two screws
5
to fasten the headphone hook
6
.
* Be careful not to use screws
4
by mistake.
Screws
5
(4 x 16 mm)
6
5
2. Connect the pedal cord to the Pedal jack, and fasten
the pedal cord with the single cable fastener.
Cable fastener
Pedal cord
Don’t remove the two cable fasteners or
the belt that holds the AC adaptor in place.
NOTE
The pedal cord plug may be damaged if you rotate it while the plug
is only halfway inserted.
Check the illustration above to make sure that the plug faces
correctly before you insert it.
Do not rotate while plug is inserted!
3. Insert the included power cord into the AC adaptor,
and use a cable fastener to secure it (one location).
To AC outlet
Power cord
Cable fastener
4. Insert the power cord plug into an AC outlet.
5. As necessary, ax cord clamps
7
to fasten the pedal
cord.
This completes assembly.
11