Roland GR-1 - Page 48

4. Selecting a Hew Original Tone
ET
S initializing the
a hi
ie new
n after u evious Tone are still in
effect. Thi you return to the one, you will get th me sound you
had before. When you want to the sound of the new Tone as it was set orig y tthe previous
condition before you tweaked it with the knobs). you could set all seven knobs to their center
ret, follow the procedure below. It has the same t but takes a fot less time.
g" the Ist for 2nd) Tone. (1n the following. the information in parentheses
fers specifically to the 2nd Tone.)
© Press| PATCH |.
RES AAPA SORIA SED TEER USES ARTUR EEE
@® Press PARAMETER [NEXT ]two (three) times.
This scrolis the display so it reads “IST TONE” ("2ND TONE
The displuy will change to read "DTUN."
Na Mey
font
24
ny
Ru]
pe
Ny
© Press| YES/ENTER |.
he "OK?" message will flash to ask you to confirm that you want to initialize the Ist (2nd) Tone.
& Press| YES/ENTEH |to confirm and start the operation.
The display reads "COMPLETE" when initialization is finish
USTEDES TE EES EES TEES LEESON PERE EU PEN AEE SESS SEEDS NESTS