Roland GR-1 - Page 71

4. A Little More Detail About Editing 1st/2nd
Tone Seitings
We talked about using the panel knobs to edit the Ist and 2nd Tones in Section 3. "Patch Ed:
ng Using the Knobs.” Now lets go buck to
that discussion and add some details about how to do similar things in the Patch Edit mode.
How to: Make ist Tone Settings
CD Press EDIT [PATCH].
The * Q” will flash.
Q Press the PARAMETER button two (2) times.
H
The “ 2” will fash.
@ Press [ENTERIYES ].
You'll see the following screen, indicating that you're ready to make settings for the Ist Tone
The “ 2" will stop flashing.
@ Now, by pressing PARAMETER [NEXT] and [PREVIOUS] you can select the 1st Tone
parameter that you want to set.
© The settings themselves are made by pressing the VALUE | INC jand] DEC |buttons.
& Repeat Step:
and Ẹ as many times as necessary to make all the settings you want.
D When you're finished, press| EXIT/NO |two (2) times to return to the Play mode.
* And as always, you need to save any changes you make with Patch Write (<7 P. 3-14)
How to: Make 2nd Tone Settings
Basically, this procedure will be identical to what we just did for the ist Tone, except that in
QU will have to press the PARAMETER | NEXT | button three (3) times to get to the
screen thatsays" 232. ENP 7 " From there on, it's the same until Step
you have to push the [ EXIT/NO [button two (2) times to exit to the Play mode
Step
ihere
* This applies to the 2nd Tone as well: don't forget to save your settings! See Patch Write
(er P. 3-14).
4—15