87
Error Messages
* External Media: USB memory, Floppy Disk, CD-ROM, etc.
Indication
Meaning
Error: 1
You can only read the music file. It can not be saved.
Error: 2
An error occurred during writing.
The external media’s protect tab may be in the “Protect” (writing prohibited) position, or the external
media may not yet be initialized.
Error: 10
No external media is inserted. Insert the external media and try again.
Error: 11
There is not sufficient free memory in the save destination. Either insert other external media or delete
unneeded files and try again.
Error: 14
An error occurred during writing. The external media may be corrupted. Insert other external media
and try again. Alternatively, you can initialize the external media.
Error: 15
The file is unreadable. The data format is not compatible with the HP203.
Error: 16
Data was not called up in time for playback of the song. After waiting several seconds, you may be
able to play back the song by pressing the [ ] button again.
Error: 18
This audio format is not supported.
Please use 44.1 kHz 16-bit linear WAV format audio files.
Error: 30
The internal memory capacity of the HP203 is full.
Error: 40
The HP203 cannot deal with the excessive MIDI data sent from the external MIDI device. Reduce the
amount of MIDI data sent to the HP203.
Error: 41
A MIDI cable has been disconnected. Connect it properly and securely.
Error: 43
A MIDI transmission error has occurred. Check the MIDI cable and connected MIDI device.
Error: 51
There may be a problem with the system. Repeat the procedure from the beginning. If it is not solved
after you have tried several times, contact the Roland service center.
Error: 65
The External Memory port was subjected to excessive current. Make sure that there is no problem
with the external media, then turn the power off, then on again.
HP203_e.book 87 ページ ２００６年１２月８日 金曜日 午前９時３３分
To Next Page
Loading...
