Roland HP506 - Sound Customization

Performing
Adjusting the Sound to Your Taste
The HP508 lets you add reverberation or modify the brightness of the sound.
Adding Reverberation to the Sound (Ambience)
You can add a pleasant reverberation to the sounds of the HP508, producing the impression that you are performing in a concert hall.
This eect is called “Ambience.”
2
1 3
1. Press the [Ambience] button.
The [Ambience] button will light.
2. While holding down the [Ambience] button, press the [–] [+] buttons.
The display will indicate the depth of the ambience eect values.
Screen Value Explanation
1–10
(default: 2)
Higher values apply deeper ambience.
* If you’re using headphones and the Headphones 3D Ambience eect (p. 50) is set to “On,” this lets you adjust
the depth of the Headphones 3D Ambience eect.
3. To turn o the ambience eect, press the [Ambience] button once again.
The [Ambience] button will go out.
* It’s not possible to specify the depth of ambience individually for each tone. The eect will be applied in the same way to each tone.
Saving your settings
The HP508’s settings will revert to
the default values when you turn o
the power, but you can save them as
described in “Retaining the Settings Even
After Power-o (Memory Backup)” (p. 44).
22