Roland Juno-6 - Page 19

20
[8]
SQUARE-WAVE
The sound
source
is the
square wave
of the
Sub
Oscillator. Set the
TRANSPOSE
to
UP.
Adding the
CHORUS effect might be inter-
esting.
[9]
STEAM
ORGAN
The Self
Oscillation
of
the VCF is used
as
a
sound
source as well
as
the
Square
Wave
of
the
DCO. Set
the FREQ
in the VCF
to
'0'
and
turn
it up a
little by little
while
pressing
the note
C.
You will
hear the sound
of
the
DCO
(note C)
first, and
then the
sound by
the
VCF
Self
Oscillation
will
be
joined. So
adjust
the FREQ
of the oscillating
VCF
until
it is an
octave and a
5th
higher than
the DCO.
CMD
10:
10]
ELECTRIC
PIANO
I
Adjust the D
and
R
in the
ENV
as
you
like.
By
setting the
FREQ
in
the HPF
to
'0'
and
turning the
CHORUS
II on, you
can get a
Honky Tonk like sound.
[ir ELECTRIC
PIANO II
This
sound contains
very
few
high
harmonics.
Like
[7]
, adjust
the
FREQ
in the VCF
so
that
only the fundamental can
pass.
Adjust
the Decay
Time and the
Release
Time
in
the
ENV
according to
your
preference.
la
Or
030
i