Roland JUNO-Gi - Page 9

9
You can easily convert a User patch into a Song patch, or vice versa,
by loading the patch or the song in which it resides, and re-saving the
patch in the desired group.
The End
We hope you’ve found this workshop helpful. Keep an eye out for
other JUNO-Gi Workshop booklets available for downloading at
www.RolandUS.com.
4 Press 6 (NEXT) to display the INSERT FX screen where you choose a
location for your patch.
5 To save it in
• the JUNO-Gi’s User library—so it can be used in any song, press
1 (USER) so the onscreen label’s highlighted, if it isn’t already.
• the current song—so it’s stored on your SD card along with the
song, press 2 (SONG) so it’s highlighted.
6 Turn the dial or use DEC and INC to choose a location within the
selected memory area in which to save your patch.
If there’s a patch already stored in the location you choose, it’ll be
replaced by the new patch if you continue. Be sure there’s nothing in
the location you wish to keep before proceeding, or choose another
location.
7 Press 6 (WRITE) to proceed, or 5 (BACK) if you’d like to make a last-
minute change to the patch’s name.
The JUNO-Gi asks if you’re sure you want to proceed.
8 Press 5 (EXEC) to finish saving your patch, or 6 (CANCEL) if you don’t
want to continue.
If you press 5 (EXEC) in Step 8, the JUNO-Gi briefly displays
Insert FX Write...
followed by:
Insert FX Write...
Completed!