Panel
Descriprions
Front Panel
O
[VOLUME] Knob
This kiiob
adjusts
the overall
volume
output
from the MIX
OUT and PHONES jacks. The
volume
from
the OUTPUT 1
and OUTPUT 2 jacks
cannot be adjusted.
O PHONES
Jack
Connect stereo headphones
(Roland
RH-20/80/120
or sim-
ilar) to this jack. (Be sure the headphones you
use have an
impedance betvi^een
8 and 15 Ohms.)
B.
O
Display
The display indicates a variety of information (selected
sounds, parameter values etc.) and operational
instruc-
tions.
O
[1-8/9-16]
Button
This button switches you between the Part Groups
(1
—8
or
9
—
16)
that can be selected
in the Performance mode or
GM
mode.
O
[PALETTE] Button
Pressing this button during editing
displays
a
number of
Tone (or Part) values for a single
parameter.
O
[PARAMETER] Button
Once
this button has been pressed, the [FUNCTION
SELECT] buttons can be used to
select the parameter
group you
wish
to edit.
D.
O
[FUNCTION SELECT] Buttons
When the [PARAMETER] button is dark, these buttons can
be used to select
the Tone or Part to be played (TONE
SWITCH
and
PART SWITCH), or to select the Tone or Part
to be edited (TONE SELECT
and
PART SELECT).
When
the [PARAMETER] button
is lit, these buttons can be used
to choose a parameter group
for editing.
E.
O
[VALUE] Knob
This knob is
used to change the value of a
parameter.
Rotating the knob
while pressing it in causes the parame-
ter value to
change
more
rapidly.
O [INC] and [DEC] Buttons
These buttons are used for
'fine-tuning' the value of a
parameter.
Pressing [INC] increases the selected
parameter
by
1,
and each press of [DEC] decreases
the value
by
1
.
O PAGE
Buttons ([A] and
[T])
Pressing either of these buttons
while "m
"
or
"*"
is
shown on the left side
of the display
causes
the display
(page) to change. [A]
shows the previous page and [T]
shows the next page.
O
CURSOR Buttons
([<]
and
[])
These buttons are used to
move the cursor (imderline) that
appears in the
display, or to select a command. Press [<]
to move to the
left or
[]
to
move to the right.
F.
O [PERFORM] Button
(GM Button)
Press this button to select the Performance mode. Pressing
this button
while
holding down the [SHIFT]
button selects
the GM mode.
O
[PATCH] Button
Press tills button to
select
the
Patch
mode.
Pressing this
button while holding down the [PERFORM]
button calls
up the Patches
assigned
to
the selected
Part.
O
[RHYTHM] Button
Press
this button to select the Rhytlim Set mode.
O [SYSTEM]
Button
Press this button to set functions that affect the entire
_JV-
IDBD.
O
[UTILITY] Button
Press this button to write, copy, or perform
a
bulk dump of
data.
To Next Page
Loading...
