Roland JV-1080 - Page 7

Rear Panel
O
[EFFECT ON/OFF]
Button
Pressing
this button displays the
effect status
(EFX,
Chorus,
and Reverb
ON/OFF). You can use this screen
to
switch these effects on
or off.
G.
O [SHIFT] Button
TTiis
button is always pressed
in combination with
another
panel
button; together they access
an additional
function.
O
[EXIT] Button
Press
this button to return to
the previous screen
or
to
'escape'
from the Edit mode to
the Play mode.
O
[ENTER]
Button
This button is used to confirm or
execute a command.
H.
O
[SOUND
GROUP]
Buttons
These
buttons are
used to select
the Tone Memory
Group;
User, Card,
Preset, or Expansion.
I.
O
PCM Card
Slot
This slot is for
inserting a PCM
card (containing
additional
PCM
waveforms).
O
DATA Card
Slot
This slot is for
inserting a DATA
card (for storing
or load-
mg Patch
data).
J.
O
MIDI Message
Indicator
This
indicator lights
when MIDI
messages are being
received.
O [POWER]
Switch
Tliis
switch turns
the
JV
on and off.
K.
O
AC Inlet
Connect the included
power cord to this inlet.
O
MIDI
Jacks
(IN/OUT/THRU)
These jacks are used to
connect the
JV-IDBO
to other
MIDI devices when exchanging
MIDI messages. (Special
MIDI
cables
are
used.)
* *
t
MIDI IN:
Receives messages from
external MIDI devices.
MIDI OUT:
Transmits messages from the
JV-IDBD
to
external
MIDI devices.
MIDI THRU:
Re-transmits the messages
received
via
MIDI
IN.
M.
O OUTPUT 1 and
OUTPUT 2
Jacks
These jacks are
for stereo output of
sounds; dry sounds
(without effects) or effect
sounds
only.
N.
O
MIX OUT
Jacks
These jacks are for stereo
(L/R) output of the
JV's
audio
signals to an amp or
mixer. For monaural
output, connect
the
external device to the L jack.