Roland JV-880 - Output Reverb Send; Output Select

Output
reverb
send
Rhyihfi: C4 C
INT&MIDI ]
u
t- p u t- r* © y
6*
T"
b s s* n
d
=
3 M
output
mode
=
20UT
Reverb
switch
=
ON
This
parameter
determines the level of the signal sent to
the reverb unit.
This setting changes
the
amount of
the
reverb applied
to each
Rhythm
Tone.
Range:
—
127
The
greater the value, the greater the level of the
signal sent to the
reverb unit.
Output select
Rhythn: C4
[INT&MIDI]
Output
seleGt
=
r'1fiIN
Output
mode
=
40UT
This
parameter determines which set of stereo outputs
will
be
used when the output
mode setting (See
P.
5-4)
of the
System Common parameter is set to
"40UT."
Settings:
MAIN/SUB
MAIN
: Output
through MAIN OUTPUT jacks
SUB :
Output through SUB OUTPUT jacks
MAIN OUTPUT
MAIN
x:
L
R
SUB
OUTPUT
*
The
final output
assignment of the Patch,
when playing in the
Performance Play mode, is
determined by
the output
setting
(See
P.7-15) in
the Performance Part parameters.
8-22