RISK OF ELECTRIC SHOCK
^
m
I
DO
NOT
OPEN
I ^HJ^k
ATTENTION
:
risque de choc electrique ne
pas
ouvrir
CAUTION:
TO
REDUCE
THE RISK OF
ELECTRIC
SHOCK,
DO
NOT
REMOVE
COVER (OR
BACK).
NO
USER-SERVICEABLE PARTS INSIDE.
REFER
SERVICING
TO
QUALIFIED SERVICE
PERSONNEL.
A
A
The lightning flash with
arrowhead symbol, within an
equilateral
triangle,
is
intended
to
alert
the user
to
the
presence
of un-
insulated
"dangerous
voltage" within the
product's
enclosure
that may
be
of
sufficient
magnitude
to constitute
a
risk of
electric shock to
persons.
The exclamation
point
within an equilateral
triangle
is intended
to alert the
user to the
presence of
important
operating
and
maintenance (sen/icing)
instructions in the
literature
accom-
panying the product.
INSTRUCTIONS
PERTAINING TO A
RISK
OF
FIRE, ELECTRIC SHOCK, OR
INJURY
TO
PERSONS.
IMPORTANT
SAFETY
INSTRUCTIONS
WARNING
—
When
using electric products,
basic
precautions should
always
be
followed, including the
following:
1
.
Read all the instructions
before
using
the
product.
2.
Do not use
this product near
water
—
for
example, near
a
bathtub,
washbowl, kitchen
sink, in
a
wet basement, or
near
a
swimming pool, or the like.
3. This product should
be used only
with
a
cart or stand
that is
recommended
by
the
manufacturer.
4. This
product,
either
alone or in combination
with an
amplifier
and headphones or speakers,
may be
capable of
producing
sound
levels that could
cause permanent hearing
loss. Do
not
operate
for a
long
period
of
time at a
high volume level
or
at a
level that is
uncomfortable. If you
experience
any
hearing
loss or ringing in
the ears, you
should consult
an
audiologist.
5. The
product
should
be
located
so
that its
location
or position
does not
interfere with its
proper
ventilation.
6. The
product
should
be
located
away
from heat sources
such
as
radiators, heat registers, or
other
products that
produce heat.
7.
Avoid
using the product where it may be
affected by
dust.
8. The product should be connected
to a
power supply only
of
the
type described in the operating instructions
or as
marked
on
the product.
9. The
power-supply
cord of
the product
should
be
unplugged
from the
outlet
when left unused
for
a
long period
of
time.
1
0.
Do
not tread on the
power-supply
cord.
1
1
.
Do
not
pull the cord but
hold the plug
when
unplugging.
1
2. When
setting
up
with any
other instruments, the procedure
should be
followed
in
accordance with
instnjction
manual.
1 3. Care
should be
taken
so
that objects do
not
fall and liquids
are
not spilled into the
enclosure through
openings.
14.
The
product
should
be
serviced
by
qualified
service
per-
sonnel
when:
A.
The
power-supply cord or the
plug
has
been damaged;
or
B.
Objects have
fallen,
or
liquid
has
been spilled
into the
product; or
C.
The product has been exposed to rain; or
D.
The product
does
not appear
to
operate normally
or
exhibits a marked
change in
performance; or
E.
The product has
been
dropped, or the
enclosure dam-
aged.
15.
Do
not
attempt to service the product
beyond that
described
in the
user-maintenance
instructions. All other servicing
should
be
referred
to
qualified service personnel.
For
Canada-
For
Polarized
Attachment
Plug
CAUTION:
TO
PREVENT
ELECTRIC SHOCK,
MATCH WIDE
BLADE
OF PLUG TO
WIDE
SLOT,
FULLY INSERT.
ATENTiON:
POUR EVITER
LES CHOCS
ELECTRIQUES,
INTRODUIRE LA LAME LA
PLUS
LARGE
DE
LA
FICHE
DANS
LA
BORNE CORRESPONDANTE
DE
LA
PRISE ET POUSSER
JUSQU'
AU fOND.
SAVE THESE INSTRUCTIONS
For the
U.K.
WARNING: THIS
APPARATUS
MUST BE
EARTHED
IMPORTANT: THE WIRES
IN
THIS MAINS LEAD ARE COLOURED
IN
ACCORDANCE WITH
THE
FOLLOWING
CODE.
GREEN-AND-YELLOW:
EARTH, BLUE: NEUTRAL,
BROWN:
LIVE
As the colours
of
the wires in
the mains
lead of
this
apparatus
may not
correspond
with the coloured markings identifying
the
terminals in
your plug proceed as
follows:
The
wire
which
is coloured
GREEN-AND-YELLOW
must be
connected
to the
terminal
in the
plug which
is
marked
by
the
letter
E or
by the safety earth symbol
@
or
coloured GREEN
or
GREEN-AND-YELLOW.
The
wire
which
is coloured
BLUE
must be
connected
to the
terminal
which is
marked with
the letter
N or coloured
BLACK.
The
wire
which
is coloured
BROWN must
be
connected to the
terminal
which
is
marked
with the letter L
or coloured RED.
The
product which
is equipped with
a
THREE
WIRE
GROUNDING TYPE AC
PLUG
must be grounded.