JX-305 Sep. 1998
10
Exiting the TEST MODE
When Bender Test ends, the following display appear.
Press [ENTER] button to load the factory preset data.
NOTE: It takes about 1 minute to complete the data loading.
Never turn the power off while this procedure.
Test Item
The JX-305 has the following 11 items.
Some test items will be started automatically, when the next
previous test ends normally.
1. Memory Test [SHIFT] + [BANK 1]
2. MIDI Test [SHIFT] + [BANK 2]
(Identifying the Program Version)
3. Card Test [SHIFT] + [BANK 3]
4. Pedal Test [SHIFT] + [BANK 4]
5. SW/LED Test [SHIFT] + [BANK 5]
6. A/D Test [SHIFT] + [BANK 6]
7. After Touch Test [SHIFT] + [BANK 7]
8. Sound Test [SHIFT] + [BANK 8]
9. DSP Test [SHIFT] + [NUMBER 1]
10.LCD & Encoder Test [SHIFT] + [NUMBER 2]
11.
Bender Test& Factory Data Set
[SHIFT] + [NUMBER 8]
• Exiting the each Test item
Press [ENTER] while holding down [EXIT].
The test will be suspended and JX-305 return to basic
test mode display.
NOTE: When LCD displays "Factory Data Set ok ?" in 11.,
the test can not be suspended.
1. Memory Test
1-1. Press [ENTER] in the basic test display. Memory Test
will be started.
The following display will appear.
1-2. When the test of the each device end, display --- will
change to "ok" or "NG". If test result are "ok", next test
runs automatically.
Troubleshooting for Memory test
2. MIDI test
When Memory Test ends normally, MIDI Test runs
automatically.
(or in the initial display of the test mode, press [BANK 2]
while holding down [SHIFT])
2-1. When MIDI test starts, following display appears.
2-2. Make a loop with MIDI cable that connects MIDI IN
and MIDI OUT.
Does the LCD display "ok" ?
2-3. When the LCD display "ok", Press [ENTER]. The
system program version will be displayed.
And press the [ENTER] again. You can check the
program version number of the CPU and Preset Data.
To Next Page
Loading...
