Roland JX-3P - Edit

(2)Write one
of these voices
as instructed
in
"A) Writing
(2)
to
(5)".
Then write
the rest of
the voices
one by
one.
—
"Hie foliowing
is the
overdubbing pro-
cedures.
—
(3}Turn the JX-3P
to the overdubbing
mode bypressing the
Sequencer Write
button
@
while holding
the Tie but-
ton
@
down.
11
(7)
Return the
Ext. Selector switch
to the
Memory
Protect
On position.
Memory
Protect On
-^^
(4)Write
the next part (voice}.
(5)lf writing
is completed,
leave the over-
dubbing
mode by pressing
the Start/
Stop button, and
the written
part wilt
be played.
Pressing the
Start/Stop
but-
ton
once again
stops the
sequencer.
{6)Repeat the
same procedures
(3)
to
(5)
and
write the rest of
the voices.
*When the JX-3P
is in
the overdubbing
mode, you can listen
to the part
previous-
ly written even
while
writing a new part.
It,
however,
is also
possible
to hear only
the part which-you
are
actually writing,
by
pressing
the Mute
button®
{The indi-
cator
will go out).
Overdubbing
(b)will
sound
Cc)will sound
Also, if more than 7 notes
(voices) are
writ-
ten, the last 6 notes
will
stay.
[e.g.]
Writing
the
seventh
voice
will erase
the 1st part.
®-
©-
@-
6 Voices
(D-
[2]
Edit
You
can edit the
data by pressing
the Sequ-
encer
Write
button
@
during
writing.
Each
time
you press
the Sequencer Write
button
^4}
,
one step
goes back
and it is
erased at the same
time.
^During overdubbing,
the
data you can
edit
by using
this
function
is up
to the
step where
you started overdubbing.
You
cannot
go
any further
step
than
this start-
ing position even
if keep
pressing
the
button.
Data
Maximum range
]
to go back
Data already
written
Data being
ovenJubbed
Maximum range
to go
back