Roland JX-3P - Page 19

19
2}
Indicators
If you select
the editing element
by pres-
sing the buttons,
the indicatorof
the
Bank
button
{A to
D) or Tone Selector button
(1
to
16)
will iight
displaying
the level or
mode of that
chosen element.
3)
Actual editing
Pr^s
the Bank button
(A to D) or move
the Sens knob
@
until you obtain the
desired
sound,
and the indicators will show
you how
it is being
changed.
•
Bank buttons
As shown
in the table
at pages 21
to
27,
press the
appropritate
button
(A to D}.
•
Sens
knob
if this knob
is set
to zero, the indicator
of
the Tone Selector
button
1 will light up.
As you raise the
knob, the
indicator of
the bigger
number will
light
up.
QnnajjDi::]
:E
IS -bi Ej. 10
E3
3-
[e.g.] Editing String
i
•
Changing the Waveform of
the
DCO-1
(1
)The Waveform
of the
DCOI Is
Number
2 in the
Group A, so press the
Group A
button
@
then
the Tone Selector
but-
ton
2. The corresponding
indicators will
flash displaying
that A-2 (Waveform of
the
DCO-1 ) is now ready
to be changed.
Tzm
-^- BQ
{2)0ne of the indicators of
the Bank but-
tons
(A to
D)
will
tight up
showing
which
Waveform
is being used in the
existing patch (Refer
to P.21).
If the
indicator
of
the Bank button
A
lights
up,
it means that saw tooth wave is
used.
aa
mar
-V fU
fU
(3)
Select the
new
Waveform
by pressing
the appropritate
Bank button
(A to D).
•Changing" the Cutoff
Frequency of the
VCF
{l)The Cutoff
Frequency
of the VCF cor-
responds to number 1 in
the Group B,
so press the Group
B
button
^
,
then
the Tone Selector
button 1. The indi-
cator of the both buttons will flash
showing that now B-1 (Cutoff Frequ-
ency in the VCF) is ready to be chang-
ed.
-^-
{2)The Cutoff
point of the
existing patch
will be displayed by
a lighting
indicator
of the Tone
Selector
button
(1 to
16).
(Refer
to the figure
on
P.19.)
If the
indicator of the Tone
Selector button
8
lights up, it shows that
Cutoff Point
is
being set to
5 in the existing
patch.
-nr
^nnnnn
E3
(3)Set
a
new Cutoff Point
by moving the
Sens knob
(@.