Roland JX-3P - Important Notes

Features
•The Roland JX-3P
is a preset type,
6
voice polyphonic
synthesizer.
•
32
kinds
of pre-programmed
patches
are
ready to be used
simply
by pressing the
buttons.
•
By
setting
up the optional
programmer
PG-200
to this JX-3P,
32 more patches
can be
synthesized
and written into
me-
mory. It is
also possible
to temporarily
edit any
program
in memory.
•The
built-in polyphonic
sequencer
that
allows up to 128 automatic
playing.
•You can save
the
patch programs and
sequencer
data
into an ordinary tape
recorder.
•
Its sound source
DCO
(Digitally Control-
led Oscillator) generates
an
extremely
stable pitch.
Moreover,
its Dual
DCO
sys-
tem
(6
voices
-
12
DCO's) enables the
user to obtain a rich and
realistic sound,
synchro
tone and metalic sound.
•This is the complete 6 voice synthesizer
provided with
6
VCF's,
6 VCA's and 6
ENV's.
•
The
built-in chorus effect makes expan-
sive sounds
available.
•Transposition to
any key Is
possible by
the
Transpose function.
•
Battery back up
system
to
retain
the pro-
grams even when switched off.
•The JX-3P can be set up with any sequ-
encer or
synthesizer if it is provided with
the MIDI
BUS
connector.
1 .
Important
Notes
Power Supply
•
The appropriate
power supply for this
unit is shown on its name plate. Please
make sure that the voltage
system in
your
country meets that.
•
When
setting
up the JX-3P with an ex-
ternal amplifier, turn
both
of
them
off
and
plug in
the JX-3P first, then the am-
plifier.
•
This unit might
not work properly if
turned
on
immediately after turned off.
If this happens, simply turn
it
off
again
and
turn
it on a few seconds later.
•This unit might get hot
while operating,
but there is no need
to worry about it.
•
Avoid using
the
JX-3P in excessive
heat
or humidity or
where
it may be affected
by
direct sunlight
or dust.
Cleaning
•
Use a
soft
cloth
and
clean
only
with
a
neutral detergent.
•
Do
not use solvents such as
paint thinner.
Repairing
•
Save the necessary data before having
the
JX-3P repaired.
Location
•
Operating the JX-3P near
a neon or fluo-
rescent lamp
may cause
noise inter-
ference. If
so, change the angle of
the JX-
3P.