Roland KC-300 - SPECIFICATIONS; Rated Power Output; Nominal Input Level; Nominal Output Level

ry
o
£
S
&
ia
=)
3
S
2°
a
>
x
w
E
——
— =—_
min. 100 cm (40 inches) rere
SPECIFICATIONS
Rated Power Output
Speaker Out 100 W / 8 ohm
Nominal Input Level (@1 kHz)
INPUT
Channel 1 MIC -50 dBm
Channel 1 LINE -20 dBm
Channel 2, 3, 4 -20 dBm
STEREO LINK IN 0 dBm
Nominal Output Level (@1 kHz)
STEREO LINK OUT 0 dBm
LINE OUT +4 dBm
0 dBm = 0.775 Vrms
Speakers
30 cm (12 inches) x 1 + Horn Driver x 1
Controls
Channel 1 Volume Knob (MIC/LINE)
Channel 2 Volume Knob (STEREO)
Channel 3 Volume Knob (STEREO)
Channel 4 Volume Knob (MONITOR)
Line Out LEVEL Knob
LOW Knob
HIGH Knob
VOLUME Knob
POWER Switch
Connectors
Channel 1 MIC Input Jack
1/4 inch T/R/S phone type balanced
Channel 1 LINE Input Jack
( E This product complies with the requirements of European Directives EMC 89/336/EEC and LVD 73/23/EEC.
* Use a speaker stand that has a load capacity of 20 kg (44 Ib.)
or greater.
* If you use a speaker stand, adjust the height to 120 cm (47
inches) or less, and adjust the legs to a width of 100 cm (40
inches) or more.
When mounting this unit on a speaker stand, you must
have at least one additional person help you, so as to
avoid pinched fingers or accidents that might be caused
should the unit be dropped.
When using the unit with a speaker stand recommend-
0.: by Roland, the speaker stand must be carefully
placed so it is level and sure to remain stable.
Cables connected to this unit should be given enough
slack to prevent accidents that might result from some-
one tripping over them.
Channel 3 Input Jacks (L/MONO, R)
Channel 4 Input Jack (MONITOR)
LINE OUT Jacks
(1/4 inch T/R/S phone type balanced MONO, L, R)
STEREO LINK OUT Jack
STEREO LINK IN Jack
PHONES Out Jack
Power Supply
AC 117 V, 230 V or 240 V
Power Consumption
80 W
Dimensions
482 (W) x 350 (D) x 477 (H) mm
19 (W) x 13-13/16 (D) x 18-13/16 (H) inches
Weight
17.5 kg / 38 Ibs 10 oz
Accessories
Owner's Manual
Options
Speaker Stand SS-115A
Speaker Cap SS-CAP
* When using an SS-115A speaker stand, be sure to use an SS-
CAP speaker cap in conjunction with it.
* In the interest of product improvement, the specifications
and/or appearance of this unit are subject to change with-
out prior notice.
For Europe