Roland KC-600 - Input Output Test

22
Jan. 2018 KC-600
Input Output Test
Items Required
• Oscillator
•Noise meter
• DI-1 (ATT switch: -40 dB)
• Dummy plug (x 2)
• Dummy resistances (8Ω x 1)
• Connection cables
• 1/4-inch stereo phone plug with 33Ω load resistors
fig.33-dummy-plug.eps
Testing Method
Following the table below, input the indicated signal to each input jack,
and verify that a signal with the indicated value is output via the
corresponding output jack.
* For PHONES OUT Test, connect a 1/4-inch stereo phone plug with 33Ω load
resistors to the PHONES jack.
* Input a balanced signal to the CH1 BALANCED connector via DI-1. Set the
ATT switch on the DI-1 to -40 dB and input the signal indicated on the table to
the INPUT jack on the DI-1.
* Connect a 8Ω dummy resistance to the output terminals for the speaker instead
of the speaker.
* Amp output is BTL (bridge output). When connecting the measuring device,
take the another ground.
* When connecting a plug to the PHONES jack on this product, speaker’s sound
is not muted.
* Speaker produces a small sound in PHONES OUT Test, however this is a
normal operation.
w
33
33
Setting Input Jack Input Signal
Output Jack/Termi-
nals
Output Level
LINE OUT Test
CH 1–4: Max
OUTPUT SEL: B
AUX IN: Max
PHONES: Min
EQ LOW/MID/HIGH: Center
SHAPE: OFF
MASTER: Min
CH1 L/MONO
(CH1 R: Insert Open
Plug)
1 kHz, -50 dBm, Sin
LINE OUT L/MONO
(LINE OUT R: Insert
open Plug)
-4.0 dBm±3.0 dB
CH2 L/MONO
(CH2 R: Insert Open
Plug)
1 kHz, -20 dBm, Sin +3.5 dBm±3.0 dB
CH3 L/MONO
(CH3 R: Insert Open
Plug)
1 kHz, -20 dBm, Sin +3.5 dBm±3.0 dB
CH4 L/MONO
(CH4: R Insert Open
Plug)
1 kHz, -20 dBm, Sin +3.5 dBm±3.0 dB
AUX IN STEREO L
(Mini)
1 kHz, -10 dBm, Sin -1.0 dBm±3.0 dB
AUX IN L (RCA pho-
no)
1 kHz, -10 dBm, Sin -4.0 dBm±3.0 dB
CH1 R 1 kHz, -50 dBm, Sin
LINE OUT R
-4.0 dBm±3.0 dB
CH2 R 1 kHz, -20 dBm, Sin +3.5 dBm±3.0 dB
CH3 R 1 kHz, -20 dBm, Sin +3.5 dBm±3.0 dB
CH4 R 1 kHz, -20 dBm, Sin +3.5 dBm±3.0 dB
AUX IN STEREO R
(Mini)
1 kHz, -10 dBm, Sin -1.0 dBm±3.0 dB
AUX IN R (RCA pho-
no)
1 kHz, -10 dBm, Sin -4.0 dBm±3.0 dB
CH1 BALANCED
1 kHz, -15 dBm, Sin (to
DI-1 INPUT)
LINE OUT L/MONO
(LINE OUT R: Not In-
sert Plug)
-10.0 dBm±3.0 dB
CH1 L/MONO
(CH1 R: Not Insert
Plug)
1 kHz, -50 dBm, Sin -4.0 dBm±3.0 dB
CH2 L/MONO
(CH2 R: Not Insert
Plug)
1 kHz, -20 dBm, Sin +3.5 dBm±3.0 dB
CH3 L/MONO
(CH3 R: Not Insert
Plug)
1 kHz, -20 dBm, Sin +3.5 dBm±3.0 dB
CH4 L/MONO
(CH4 R: Not Insert
Plug)
1 kHz, -20 dBm, Sin +3.5 dBm±3.0 dB
AUX IN L
(RCA phono)
1 kHz, -10 dBm, Sin -10.0 dBm±3.0 dB
AUX IN R
(RCA phono)
1 kHz, -10 dBm, Sin -10.0 dBm±3.0 dB
CH 1–4: Max
OUTPUT SEL: B
AUX IN: Max
PHONES: Min
EQ LOW/MID/HIGH: Center
SHAPE: OFF
MASTER: Min
GND LIFT: OFF
AUX IN L
(RCA phono)
1 kHz, -10 dBm, Sin
LINE OUT L
BALANCED
(HOT-GND)
-4.5 dBm±3.0 dB
1 kHz, -10 dBm, Sin
LINE OUT L
BALANCED
(COLD-GND)
-4.5 dBm±3.0 dB
AUX IN R
(RCA phono)
1 kHz, -10 dBm, Sin
LINE OUT R
BALANCED
(HOT-GND)
-4.5 dBm±3.0 dB
1 kHz, -10 dBm, Sin
LINE OUT R
BALANCED
(COLD-GND)
-4.5 dBm±3.0 dB